OK-6 Kick-Over Tool Assembly
The Rebco OK-6 Kickover Tool is a wireline service tool designed to install and retrieve
compatible 1-in. OD side-pocket subsurface-control devices in appropriate Camco side-pocket mandrels. Used with a compatible running or pulling tool, the OK-6 uses a solid centralizer sleeve to guide and stabilize the tool assembly within the tubing while the locating and kickover components position the attached service tool at the selected side pocket.
Product Code: 192
Applications
Installing compatible 1-in. OD gas-lift valves and other side-pocket subsurface-control devices.
Retrieving compatible 1-in. OD devices for replacement, inspection, or well servicing.
Positioning an attached running or pulling tool at the selected side-pocket mandrel.
Supporting wireline intervention in compatible mandrels equipped with the required orienting profile.
Key Benefits
Sleeve-type centralization: The solid centralizer sleeve provides an alternative method of guiding and stabilizing the tool in the tubing.
Controlled pocket alignment: Locating and kickover components assist in orienting the attached service tool with the side pocket.
Running and pulling capability: Supports both installation and retrieval when paired with the appropriate compatible service tool.
Alternative tool configuration: Provides a centralizer arrangement different from the spring-based OK-5 design for applications where the sleeve configuration is specified.
Notes
Kick-over | SPM | Latch | Running Tool | Pulling Tool | Pulling Spacer |
OK-1 | KBMG KBUG | BK-2 | JK-2 | 1 ¼ in. JDS 1.66 in. SM | - |
OK-6 |
OK-6 Centralizer Note: Verify that the tubing internal diameter and selected tool size are suitable for the sleeve-type centralizer configuration. Inspect the centralizer sleeve, locating finger, kick springs, and arm assembly before deployment in accordance with approved service procedures.
Redress Kits Available: Rebco offers Major & Minor redress kits and replacement components for OK-6 Kickover Tools, including applicable sleeve-centralizer and kickover components. Provide the tool size and configuration to confirm the correct kit.
TECHNICAL DATA
NOMINAL SIZE | 2 7/8” | 3” | 4 ½” |
ASSEMBLY NUMBER | 192202462500 | 192202463000 | 192202464500 |
MAXIMUM OD | 2.223” | 2.500” | 3.500” |
Tubing ID required for proper tool orientation | 2.437” | 2.921” | 3.958” |
PIN THREAD CONNECTION | 15/16” – 10 | 15/16” – 10 | 15/16” – 10 |
FISHING NECK OD | 1.375” | 1.375” | 1.375” |
LENGTH | 67.0” | 71.125” | 71.87” |
MATERIAL | Alloy | Alloy | Alloy |
ACCESSORY: | |||
Service Tool: Type ‘ST’ for Detent Spring | 5514151 | ||
Disclaimer: Information is provided for reference only. Rebco Oil Tools, Inc. makes no express or implied warranty as to the accuracy or completeness of this information. Equipment selection, configuration, and use must be performed by qualified personnel and are subject to approved procedures, well conditions, mechanical limitations, and Rebco’s Terms and Conditions of Sale.